Garage Height Calibration

If any portion of the power liftgate assembly is replaced, repaired or disassembled, perform the following liftgate calibration procedure:

1. Ensure that the rotary switch on the overhead console or driver door panel is set to 3/4.
2. Press the liftgate handle switch and allow the liftgate to power open.
3. Stop movement at the desired height by pressing any operation switch.
4. If required, manually move the stopped liftgate to the desired position.
5. Press and hold the liftgate close switch for at least 3 seconds. The tailights will flash if the setting has been successfully programmed.
   NOTE: The opening height of the liftgate should be positioned approximately parallel with the roof, the liftgate control module will reject the setting if the liftgate is positioned too low.
6. Close the liftgate completely using one of the following switches:
   • The rotary switch on the overhead console
   • The shutface switch on the liftgate
   • The remote control switch on the key fob