Unsuccessful Programming Recovery

In the event of an interrupted or unsuccessful programming event, perform the following steps:

1. Ignition ON. Ensure the frontview camera module, DLC and programming tool connections are secure and the SPS software is up to date.
2. Verify the frontview camera module can be reprogrammed.
   • If the frontview camera module cannot be reprogrammed 
   1. Ignition OFF for one minute, ignition ON.
   2. Verify the frontview camera module can be reprogrammed.
      • If the frontview camera module cannot be reprogrammed, replace the frontview camera module.
      • If the frontview camera module can be reprogrammed.
   3. All OK.
   • If the frontview camera module can be reprogrammed 
3. All OK.