Circuit/System Verification
- Ignition ON.
- Verify DTC P0231, P0232 or P023F is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
- If any of the DTCs are set
- Verify that the area where the K38 Chassis Control Module is located is free of debris, clutter, or any insulating material that would cause the K38 Chassis Control Module to overheat.
- If any debris, clutter, or other material is found
- Clear the area where the K38 Chassis Control Module is located.
- Clear the DTC and test drive the vehicle.
- Verify DTC P1255 or P064A is not set.
- If DTC P1255 or P064A is set, replace the K38 Chassis Control Module.
- If DTC P1255 or P064A is not set
- All OK.
- If no debris, clutter, or other material is found
- Clear the DTC and test drive the vehicle.
- Verify DTC P1255 or P064A is not set.
- If DTC P1255 or P064A is set
Replace the K38 Chassis Control Module.
- If DTC P1255 or P064A is not set.
- If DTC P1255 or P064A is set
- All OK.