LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2017 >> CTS Base, AWD >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Battery, Charging System And Starting System >> Diagnostic Information and Procedures >> DTC P106F: Stop-Start Capacitor Control Module Self Test Incomplete >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE:

You must perform Circuit/System Verification before Circuit/System Testing.

  1. Ignition ON.
  2. Record the value of the Stop/Start Capacitor Control Module Diagnostic Test Abort Counter scan tool parameter.
  3. Verify the Stop/Start Capacitor Voltage scan tool parameter is 2 V or greater.
    • If less than 2V 
    1. Clear the DTC, perform the Stop Start Capacitor Control State of Health Reset.
    2. Ignition OFF and all vehicle systems OFF.
    3. Wait a minimum of 3 minutes.
    4. Ignition ON
    5. Verify the Stop/Start Capacitor Control Module Diagnostic Test Abort Counter scan tool parameter value is not greater than or equal to the reading in step 2.
      • If greater than or equal to the reading in step 2, replace the K176 Stop/Start Capacitor Control Module
      • If not greater than or equal to the reading in step 2, all OK
    • If greater than or equal to 2 V 
  4. Replace the K176 Stop/Start Capacitor Control Module.
scientia non olet · About LEMON Manuals