Pedestrian Impact Detection Module Scan Tool Information
Pedestrian Impact Detection Control Module Scan Tool Data Parameters
| Parameter | Expected Value | Description |
|---|---|---|
| Operating Conditions: Engine ON | ||
| Battery Voltage Signal | Varies | This displays volts. This is the current battery voltage signal. |
| Power Mode | Run | The scan tool displays Off, Accessory, Run or Crank Request. This is the state of the ignition switch. |
| Left Hood Hinge Deployment Loop Resistance | 1.44-4.25 Ohms | The scan tool displays the resistance of the learned loop of the hood hinge when connected to the Pedestrian Impact Detection Control Module |
| Right Hood Hinge Deployment Loop Resistance | 1.44-4.25 Ohms | The scan tool displays the resistance of the learned loop of the hood hinge when connected to the Pedestrian Impact Detection Control Module |
| Pedestrian Impact Detection system Service Required Message | Requested/Not Requested | The scan tool displays Requested or Not Requested. This is the state of the Pedestrian Impact Detection system service message. |
| Pedestrian Impact Detection system Disabled Message | Requested/Not Requested | The scan tool displays Requested or Not Requested. This is the state of the Pedestrian Impact Detection system disabled message. |
| Pedestrian Impact Detection system Deployed Message | Requested/Not Requested | The scan tool displays Requested or Not Requested. This is the state of the Pedestrian Impact Detection system deployed message. |
Pedestrian Impact Detection Control Module Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Data Recorder | This output control is used to enable or disable the diagnostic data recorder. |
| Module Setup | This output control is used to setup a new Pedestrian Impact Detection Control Module. |