Fastener Specifications
Single Use Non-Threaded Fasteners/Components
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|---|
| Application |
| Transmission Fluid Cooler Pipe Fitting Retaining Clip |
| Transmission Fluid Cooler Pipe Fitting Seal |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Left Side Underbody Front Air Deflector Bolt | 9 N.m (80 lb in) |
| Range Selector Lever Cable Heat Shield Bolt | 9 N.m (80 lb in) |
| Rear Differential Inlet Hose | 9 N.m (80 lb in) |
| Rear Differential Outlet Hose | 9 N.m (80 lb in) |
| Right Side Underbody Front Air Deflector Bolt | 9 N.m (80 lb in) |
| Transmission Fluid Auxiliary Cooler Bracket Nut | 9 N.m (80 lb in) |
| Transmission Fluid Cooler Inlet and Outlet Pipe Bolt | 22 N.m (16 lb ft) |
| Transmission Fluid Cooler Inlet and Outlet Pipe Clip Bolt | 9 N.m (80 lb in) |
| Transmission Fluid Cooler Inlet and Outlet Pipe Clip Bolt at Engine Block and Front Drive Axle Housing |
22 N.m (16 lb ft) |