LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Cadillac >> 2018 >> CT6 Plug-In >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Driver Assistance Systems >> Repair Instructions >> Digital Map Module Map Update >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Digital Map Module Map Update: Notes

NOTE:
  • USB File transfer DOES NOT REQUIRE a USB memory stick. The EL-50334-14 (USB cable) connects the computer directly into the K179 Digital Map Control Module.
  • Digital Map Control Module - USB File Transfer is required when K179 Digital Map Control Module is replaced or if DTC B126B Map Data Programming is set.
  1. Remove USB cap from bottom of the K179 Digital Map Control Module. Refer to Digital Map Module Replacement  for getting access to the K179 Digital Map Control Module
  2. Connect EL-50334-14 (USB cable) into the K179 Digital Map Control Module and computer in rear compartment.
    3. NOTE:

    To connect MDI2 to computer in rear compartment, route MDI2 cable through rear seat armrest

  3. Install EL-49642  SPS Programming Support Tool
  4. Verify the Digital Map Control Module Clock Status and GPS Accuracy scan tool information is VALID. If the displayed value is not VALID, drive the vehicle with a clear view of the sky for 5 minutes (no building obstructions and a clear line of site to the sky).
  5. Access the Service Programming System (SPS) and follow the on-screen instructions.
  6. On the SPS Supported Controllers screen, select K179 Digital Map Control Module - USB File Transfer and follow the on-screen instructions.
  7. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  8. Road test the vehicle with a clear view of the sky for 5 minutes (no building obstructions and a clear line of site to the sky).
  9. Verify no DTCs have set
scientia non olet · About LEMON Manuals