Removal Procedure
WARNING: This page is about a different car, the 2023 GMC Sierra 3500 HD and 2023 GMC Sierra 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disable the SIR system. SIR Disabling and Enabling
- Reposition the front center seat.
Carefully pull the rear window lower garnish molding (1) forward around all edges then the middle of the part to disengage the clips from the sheet metal.
- After all integral clips are disengaged, lift up and forward to clear the 2 rear end panel brackets that the rear window lower garnish molding (1) sits over.
Front Seat Belt Anchor Plate Tensioner Cover (1) - Remove
- Front Seat Belt Anchor Plate Tensioner Bolt (2) - Remove
Use a small flat bladed tool to open the trim panel bolt cap (1).
- Body Lock Pillar Garnish Molding Bolt (2) - Remove
- Starting at the top and working down with a trim tool, grasp the body lock pillar garnish molding (3) and gently pull the panel away from the body to release the retainers.
- Body Lock Pillar Garnish Molding (3) - Remove
- Route the seat belt webbing through the body lock pillar garnish molding (3).
Disconnect the electrical connector.
- Release the retaining tabs.
- Remote Function Actuator Module (1) - Remove