Removal Procedure
- Place the ignition switch in the OFF position.
- Without draining the engine coolant and without disconnecting the hoses, remove and position aside the radiator surge tank. Radiator Surge Tank Replacement (LGX) , or Radiator Surge Tank Replacement (LSY)
- Thoroughly clean the electronic brake control module (EBCM) to brake pressure modulator valve (BPMV) area of any accumulated dirt and debris.
Brake Pressure Modulator Valve Master Cylinder Reservoir Front Pipe - Remove - Brake Pressure Modulator Valve Master Cylinder Reservoir Front Pipe Replacement
Brake Pressure Modulator Valve Master Cylinder Reservoir Rear Pipe - Remove - Brake Pressure Modulator Valve Master Cylinder Reservoir Rear Pipe Replacement
- Disconnect the EBCM electrical connector.
-
NOTE:
Label all the brake pipes to ensure they are re-installed in the correct ports of the brake pressure modulator valve.
Left Front Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Right Front Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Right Rear Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Left Rear Brake Pipe Fitting (1) - Disconnect
- Cap the brake pipe fitting and plug the BPMV outlet port to prevent brake fluid loss and contamination.
Brake Pressure Modulator Valve Bracket Bolt (1) - Remove
Electronic Brake Control Module with Brake Pressure Modulator Valve Assembly (1) - Remove
- Transfer components as necessary.