Replace and Program Control Module

To program a replacement K107B Drive Motor Control Module 2 perform the following procedure:

1. Replace the K107B Drive Motor Control Module 2.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
NOTE:

The K107 Drive Motor Control Module and K107B Drive Motor Control Module 2 will be programmed together.

3. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select K107 - Drive Motor Control Module - Setup and follow the on-screen instructions.
5. Clear DTCs.