System Specifications
RESISTANCE VALUESInjector [1] 1.2 Ohms min.
[1] Check across injector terminals.
VOLTAGE VALUES
Throttle Position Sensor
Voltage [1] 0.20-1.25 volts
NOTE:
[1] TPS voltage is checked at idle. The maximum TPS reading at idle is 1.25 volts.
ECM CONTROLLED RELAYS AND SOLENOIDS
Check the resistance of each ECM controlled relay or solenoid coil before replacing an ECM. Replace any relay or solenoid if the resistance measurement is less than 20 ohms. See ECM wiring diagrams under ELECTRICAL AND ELECTRONIC DIAGRAMS for coil terminal identification of solenoids and relays to be checked.