Displaying CCM Input Status

Display of CCM input status is used to determine if CCM is monitoring proper system operation.
To enter display CCM input status function, press TRIP/ODO (next test) button on DIC until "1.3" displays on trip monitor. Press ENG/MET (next value) button until identifying number for input status is displayed in the first 2 digits of odometer. See CCM INPUT IDENTIFICATION NUMBER table. Press FUEL INFO (previous value) button to go backward in the list.
Input status is displayed in the last 3 digits of odometer. Input status will display as "1" (on) or "0" (off). Display will constantly move to the left one digit at a time. First 2 digits in odometer indicate last 2 states of selected input. Third digit indicates current state of input. For example, "101" when in door ajar status indicates door was open, closed, then opened again.
If input status does not change during testing, a "1" indicates a possible short or faulty switch, and a "0" indicates a possible open or faulty switch. Exceptions to this are input status 01, 02, 06 and 14, which should not change and cannot be changed during diagnostics.

CCM INPUT IDENTIFICATION NUMBER

Input ID No.

Input (Status "1")

PASS-Key(R) Fuel (Enabled)

02 ⁽¹⁾

English/Metric Status (Metric)

Door Key Switch (On)

Right Door Ajar (Open)

Left Door Ajar (Open)

06 ⁽²⁾

Key In Ignition (Closed)

Hatch Ajar (Open)

Power Door Unlock (Yes)

Power Door Lock (Yes)

Parking Lights (On)

11 ⁽³⁾

Rear Defogger Input (On)

12 ⁽⁴⁾

Seat Belt Switch (Buckled)

13 ⁽⁵⁾

High Beam Switch Input (On)

Low Oil Level Switch (Low Oil)

⁽¹⁾	English/metric status must be selected while in normal mode (before entering diagnostic mode).

⁽²⁾	Key in ignition status is closed only if a key is present in ignition switch with switch in OFF or ACC position. If input displays "1", a malfunction must be present in switch or circuits. CCM should not detect a key with ignition switch in RUN position (position when in diagnostic mode).

⁽³⁾	Engine must be running. If equipped with electronic air conditioning system, rear defogger switch sends a short (90 millisecond) pulse when depressed. CCM may not detect pulse first time, press rear defogger switch several times.

⁽⁴⁾	Driver's seat belt only.

⁽⁵⁾	Headlights must be on.