LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1994 >> Beretta Base, 2.2 4, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Ignition Module (Dis) >> Removal & Installation (2.2L & 3.1L)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation (2.2L & 3.1L)

  1. Disconnect negative battery cable. Disconnect connectors at ignition module. See Fig 1 and Fig 2 . Disconnect spark plug wires from coil pack. Remove coil pack/ignition module assembly. For ignition module location, see COMPONENT LOCATIONS in appropriate I - SYS/COMP TESTS article in this section listed below. Separate ignition coil(s) from ignition module (if possible).
  2. To install, reverse removal procedure. Tighten ignition module mounting bolts/nuts. Tighten mounting bolts/nuts to specification. See TORQUE SPECIFICATIONS  .
Fig 1: Locating Distributorless Ignition Module Components (2.2L)
G94F32099Courtesy of GENERAL MOTORS CORP.
Fig 2: Locating Distributorless Ignition Module Components (3.1L)
G7834Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals