With A/C

REMOVE OR DISCONNECT

1. Heater control assembly. Refer to "Control Assembly and Blower Switch." Control Assembly and Blower Switch

- Pull the heater control assembly out far enough to reach the control assembly lamp bulb socket.

2. Lamp bulb and socket.

3. Lamp bulb from socket.

- Pull the lamp bulb straight out from the socket.


Inspect

- Control assembly lamp bulb socket for corrosion and damage. Clean or replace as necessary.

- Wires for damage and secure connection to the lamp bulb socket. Repair or replace as necessary.


INSTALL OR CONNECT

1. New lamp bulb.

- Push the lamp bulb straight into the socket.

2. Lamp bulb and socket.

3. Heater control assembly. Refer to "Control Assembly and Blower Switch."

- Check circuit operation.