Code P1550, Cruise Stepper Motor: Notes

Stepper motor cruise system differs from integrated (PCM-controlled) cruise system previously used in that it is a stand-alone system. PCM still retains ability to disable cruise if conditions are detected which would make cruise control operation undesirable. PCM may inhibit cruise control if the following conditions are present.

• Engine not running long enough for cruise control operation.
• Codes P0705 or P1630 set.
• Engine speed too high or too low.
• Vehicle speed too high or too low.
• Transmission range input indicates Park, Neutral, Low or Reverse gear selected.

If PCM detects any of these conditions, it will interrupt ground at cruise inhibit signal circuit to request that cruise control disengage.

1. Ensures PCM is detecting a current fault.
2. Ensures cruise status circuit is not open or grounded, or shorted to voltage, and proper voltage is being supplied by SMCC module.