Remote Unlock Control Customization
- If ignition is turned off or driver's door is opened while Body Control Module (BCM) is in any customization mode, customization procedure will end and BCM will remain in most recent mode.
- Remove BCM PRGRM fuse located in instrument panel fuse block. Close all vehicle doors and liftgate. Turn ignition switch to ACC position. Seat belt warning light flashes and chime sounds 1-4 times to indicate BCM is in feature customization mode.
- Press transmitter UNLOCK button. Seat belt warning light will flash and chime will sound 1-2 times to indicate which remote unlock control mode BCM is in. Each time transmitter UNLOCK button is pressed, mode number will advance. After mode 2, mode 1 will repeat.
- See REMOTE UNLOCK CONTROL CUSTOMIZATIO
N table. To exit and save current customization, turn ignition off and replace BCM PRGRM fuse.
REMOTE UNLOCK CONTROL CUSTOMIZATION
| Mode |
Remote Unlock Control |
| 1 |
All Doors & Liftgate Unlock |
| 2 |
Driver Door Unlock Only |
| 2 |
All Doors & Liftgate Unlock |
REMOTE ACTIVATION VERIFICATION
| Mode |
Description |
| 1 |
Remote Activation Verification Feature Disabled |
| 2 |
Exterior Lights Flash When Pressing Either Unlock Or Lock On Transmitter |
| 3 |
Exterior Lights Flash When Pressing Unlock On Transmitter Exterior Lights Flash & Horn Sounds When Pressing Lock On Transmitter |
| 4 |
Exterior Lights Flash When Pressing Unlock On Transmitter, Exterior Lights Flash When Pressing Lock Once On Transmitter & Exterior Lights Flash And Horn Sounds When Pressing Lock Second Time Within 5 Seconds |