Torque Specifications

WARNING: This page is about a different car, the 2003 Chevrolet Corvette and 2002 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

TORQUE SPECIFICATION ⁽¹⁾

Application

Ft. Lbs. (N.m)

Axle Shaft Spindle Nut

118 (160)

Outer Tie Rod End Nut

⁽²⁾ 15 (20)

Rear Suspension Adjustment Link Lock Nut

44 (60)

Rear Transverse Spring Mounting Bracket Bolts

46 (62)

Wheel Lug Nuts

100 (140)

⁽¹⁾

Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. DO NOT use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

⁽²⁾	After initial torque, turn the nut an additional 160 degrees. See Fig 1 . Check the outer tie rod end nut for a minimum torque of 33 Ft. Lbs. (45 N.m).

Fig 1: View Of Torque Angles

Courtesy of GENERAL MOTORS CORP.