Transmitter Programming

Vehicle can be programmed for up to 4 transmitters. If the number of transmitters programmed exceeds 4, previously programmed transmitters will be erased, starting with the first transmitter.

There are 3 modes within remote control door lock receiver:

• Add Mode
  
  Used to add new or additional transmitters.
• Rewrite Mode
  
  Used to erase all previously programmed transmitters. Should be used when installing a new receiver.
• Confirmation Mode
  
  Used for confirming number of existing transmitters programmed to vehicle before adding transmitters.

1. To enter programming modes, set following conditions:
   • Ignition off and key out of lock cylinder.
   • All doors closed except driver door.
   • All doors unlocked.
2. Insert ignition key into key cylinder momentarily and remove it.
3. Using switch in driver door, move switch from LOCK to UNLOCK 5 times at approximately one second intervals within 40 seconds.
4. Close drivers door, and then open it.
5. Again, move switch from LOCK to UNLOCK 5 times at approximately one second intervals within 40 seconds.
6. Insert ignition key into lock cylinder.
7. Turn ignition switch from ON to LOCK at approximately one second interval for 1-3 times according to desired mode.
   • 1 time for add mode.
   • 2 times for rewrite mode.
   • 3 times for confirmation mode.
8. Remove ignition key from key cylinder.
   • If add or rewrite mode has been selected, doors will lock, then unlock once or twice at 1 second intervals, once for add mode or twice for rewrite mode.
   • If confirmation mode is selected, doors will lock, then unlock 0-4 times at 2 second intervals to inform technician or number of transmitters programmed.
9. Press a transmitter button for 2 seconds. Doors will lock, then unlock once at a one second interval to inform technician that signal has been received from transmitter.
10. Close driver door, then open it.
11. Press a transmitter button for 2 seconds. Doors will lock, then unlock once at a one second interval to inform technician that signal has been received from transmitter.
    • If doors lock, then unlock once, transmitter programming has been completed. Go to step  9 to continue programming for additional transmitters.
    • If doors lock, then unlock twice, transmitter programming is not complete. Go to step  9 to begin transmitter programming again.

If any of the following conditions occur during programming, remote control door lock receiver will return to normal operation:

• Drivers door remains closed.
• 20 seconds elapses with no input to RKE module.
• Ignition key is inserted into ignition lock cylinder.
• 4 transmitters have been programmed at once.