LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2000 >> Corvette 2D Convertible, Automatic >> Repair and Diagnosis (Single Page) >> Steering >> Steering Column >> Steering Wheel And Steering Column >> Repair Instructions >> Telescoping Steering Column Calibration >> Telescoping Soft Stop Programming Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Telescoping Soft Stop Programming Procedure

  1. Turn ignition to ON, leaving the engine off.
  2. To set the telescoping in soft stop, press the telescoping COLUMN IN switch at least eight times or until the column moves, then release the switch.
  3. Press the telescoping COLUMN IN switch and hold the switch until the column travels all the way up, and continue to hold the switch about a second after motion stops at the mechanical end of travel. The soft stop for the column in position is now set. The seat control module automatically goes back to the normal mode of operation.
  4. Repeat steps 2 and 3, using the COLUMN OUT switch, to set the column out position soft stop.
scientia non olet · About LEMON Manuals