Transmitter Programming

Vehicle can be programmed for up to 4 transmitters. If the number of transmitters programmed exceeds 4, previously programmed transmitters will be erased, starting with the first transmitter. All transmitters to be used must be programmed in same programming sequence.

1. Connect a fused jumper (5-amp) between Data Link Connector (DLC) terminals No. 4 (Black wire) and No. 8 (Pink/White wire). Door locks will cycle once to indicate entering programming mode.
2. Within one minute, repeatedly press LOCK and UNLOCK buttons on transmitter simultaneously until door locks cycle once.
3. Within 30 seconds, repeat step  2 for each additional transmitter to be programmed.
4. Disconnect fused jumper wire to exit programming mode.