Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Monte Carlo and 2003 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Antenna Amplifier & Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Position the antenna amplifier to the inner upper panel of the left rear window. Install the antenna amplifier bolt.
Tighten: Tighten the bolt to 3 N.m (27 lb in).

IMPORTANT: The antenna coaxial cable uses a sliding snap-lock. Holding the sliding lock feature will prevent installation.

Connect the antenna amplifier electrical connectors:
1. Position the antenna coaxial cable behind the sliding lock feature.
2. Install the antenna coaxial cable to the sliding lock feature.

IMPORTANT: If the wiring clip is faulty, replace the wiring clip prior to installation.

Install the antenna leads to the rear window terminals. Push the wiring clip on the upper lead into the hex hole in the metal.
Install the upper trim panel at the left rear quarter. Refer to Trim Panel Replacement - Rear Quarter Upper (Impala) or Trim Panel Replacement - Rear Quarter Upper (Monte Carlo) in Interior Trim.