LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Venture Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Body Control Modules) >> Removal & Installation >> Door Module >> Removal & Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal & Installation

WARNING: This page is about a different car, the 2001 Cadillac Seville. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure includes all door modules.
  1. Remove appropriate inside handle bezel and screw. Lift flap in pull handle opening to access and remove 2 screws. Remove 2 screws from bottom of door trim panel. Using Door Trim Pad Clip Remover (J38778), release 8 retainers from perimeter of door trim panel.
  2. Lift upward and outward on door trim panel to disengage from top of door. Disconnect door latch cable from inside door handle by prying tab on cable outward while pulling back on cable. See Fig 1 . Unhook collar portion of the clip from cable attachment. Push upward on bottom of cable attachment to disengage cable from handle clip.
  3. Disconnect harness connectors and remove door trim panel. Disconnect harness connectors from door module. Remove door module by releasing tabs on top and bottom. See Fig 2 . To install, reverse removal procedure.
Fig 1: Removing Inside Door Handle
G98D12206Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Driver's Door Module
G00016945Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals