Section 9 (Engine Control System & Component Tests - 4.3L): Introduction
WARNING: This page is about a different variant/trim than selected.
Before testing separate components or systems, follow proper workflow. See DIAGNOSTIC PROCEDURE under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - 4.3L CHEVY EXPRESS & SAVANA article. If no Diagnostic Trouble Codes (DTC) are present and a no-start condition exists, proceed to NO-START DIAGNOSIS in BASIC DIAGNOSTIC PROCEDURES - 4.3L CHEVY EXPRESS & SAVANA article. If no DTCs are present and a driveability condition exists, proceed to SYMPTOMS in TROUBLE SHOOTING - NO CODES - 4.3L CHEVY EXPRESS & SAVANA article for diagnosis by symptom (i.e., ROUGH IDLE, ENGINE STALLS, etc.).
NOTE:
Testing individual components does not isolate shorts or opens. Perform all voltage tests with a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.