Test Description

The numbers below refer to the step numbers in the diagnostic procedures.

1. The numbers below refer to the step numbers on the diagnostic procedures.
2. 1 -  Make sure you perform the I/M System Check before performing this test. Failure to do so may result in difficulty updating the status to YES.
3. 2 -  This step is to run the HO2S Heater Tests. Preprogramming the scan tool will reduce the amount of time the oxygen sensor heaters operate while verifying the enable criteria.
4. 3 -  This step is to run the Catalyst Test. The Catalyst Test runs during the specified cruise period.
5. 4 -  This step is to run the Exhaust Gas Recirculation (EGR) tests. A steady vehicle speed is required in order to maintain a high, stable signal from the Manifold Absolute Pressure (MAP) sensor.
6. 5 -  This step is to run the oxygen sensor tests.
7. 6 -  This step is to run the EVAP tests.
8. 8 -  The I/M System Status only reports on whether or not a diagnostic has run, not the outcome of the test. If any emission related DTC sets after the tests are complete, the DTC will require diagnosis.