Installation Procedure

Fig 1: Multifunction Turn Signal Switch Assembly

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The electrical contact must rest on the turn signal cancel cam assembly.

Install the multifunction turn signal switch assembly (1) to the steering column assembly.

Fig 2: 2 Pan Head Tapping Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 pan head tapping screws (1).
Tighten: Tighten the screws to 7 N.m (62 lb in).

Fig 3: Wire Harness Assembly & Steering Column Jacket Assembly

Courtesy of GENERAL MOTORS CORP.

Fig 4: Wire Harness Assembly & Wire Harness Strap

Courtesy of GENERAL MOTORS CORP.

Fig 5: Wire Harness Straps & Steering Column Tilt Head Assembly

Courtesy of GENERAL MOTORS CORP.

Install new wire harness straps (2) to the steering column assembly (1) and the column.

Fig 6: View Of Lower And Upper Steering Column Covers

Courtesy of GENERAL MOTORS CORP.

Install the upper and lower steering column trim covers. Refer to Steering Column Trim Covers Replacement (Telescoping) or Steering Column Trim Covers Replacement (Manual) .