LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala SS >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Heated Seat Control Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Position the heater module to the front seat.
  2. Connect the electrical harness connector (1) to the heater module (2).
    3. Fig 1: Electrical Harness Connector & Heater Module
    GM816209Courtesy of GENERAL MOTORS CORP.
  3. Position the module on the frame and slide the module rearward until the module locks into place.
  4. Lower the seat.
  5. Connect the seat electrical harness connector.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the bolts that secure the front bucket seat adjuster to the floor pan.

    Tighten:  Tighten the bolts to 42 N.m (31 lb ft).

  7. Reposition the front seat to the original position.
scientia non olet · About LEMON Manuals