LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System - 3.8L (L36 And L67) - Introduction (2 Of 2) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Ignition Coil Module And Module Mounting Bracket
    GM12299Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition control module to the bracket.
  2. Install the ignition coils (2) to the ignition control module (3).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the ignition coil screws (1).

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  4. Connect the spark plug wires.
  5. Connect the 14-way electrical connector to the module.

    Tighten:  Tighten the screw to 2.1 N.m (19 lb in).

  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals