LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different car >> Section 1211 (Engine Controls/Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2012 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Knock Sensor & Bolt
    GM860801Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Position the knock sensor and tighten the knock sensor bolt to 23 N.m (17 lb ft).
    2. Fig 2: Identifying CKP Sensor & Knock Sensor
    GM1839728Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (1) to the bank 1 knock sensor.
  3. Instal the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement (LY7) .
scientia non olet · About LEMON Manuals