LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> RV Cutaway 4.8 V >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 4.8L, 5.3L, And 6.0L - Introduction >> Repair Instructions >> Accelerator Controls Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Accelerator Cable Tangs, Pedal Lever & Cable Retainer
    GM372959Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator cable through the dash panel. Snap the accelerator cable cover tangs (1) through the dash panel.
  2. Install the accelerator cable through the slot in the accelerator pedal lever (2).
  3. Seat the retainer (3) in the accelerator pedal lever (2).
    4. Fig 2: View Of Accelerator/Throttle Cable
    GM389031Courtesy of GENERAL MOTORS CORP.
  4. Connect the accelerator cable to the throttle body lever.
    5. Fig 3: Locating Accelerator Control Cable and Cruise Control Cable
    GM389853Courtesy of GENERAL MOTORS CORP.
  5. Slide the accelerator cable into the slot on the accelerator cable bracket. Snap the locking tab into position on the engine sight shield mounting bracket. Clip the accelerator cable onto the generator bracket.
    6. Fig 4: View Of Accelerator Cable At Engine Sight Shield Mounting Bracket
    GM389852Courtesy of GENERAL MOTORS CORP.
  6. Clip the accelerator cable into the engine sight shield mounting bracket.
  7. Test for complete throttle opening and closing range by operating the accelerator pedal. Also inspect the carpet fit under the accelerator pedal. The throttle should operate freely without binding between full closed throttle and wide open throttle (WOT).
  8. Install the left instrument panel insulator.
  9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  10. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
scientia non olet · About LEMON Manuals