Steering Position Sensor Calibration
WARNING: This page is about a different car, the 2005 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Install the scan tool.
- Turn ON the ignition, with the engine OFF.
- Center the steering wheel.
- With the scan tool select Special Functions.
- Select Steering Position Sensor Calibration and press the Enter key. The scan tool screen will flash Calibration in Progress.
- When done, the scan tool will display Calibration Complete.
- Press the exit key.
- Use the scan tool in order to clear the DTCs.
- Turn OFF the ignition.
IMPORTANT:
After turning OFF the ignition, allow 25 seconds of wait time before performing any procedures that require the vehicles battery to be disconnected, or module memory loss may occur.