Repair Verification
- Install any components or connectors that have been removed or replaced during diagnosis.
- Perform any adjustments, programming, or setup procedures that are required when a component or module is removed or replaced.
- Clear the DTCs.
- Turn OFF the ignition for 60 seconds. If the repair was related to a DTC, duplicate the condition for running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to Diagnostic Trouble Code (DTC) List - Vehicle and perform the appropriate diagnostic procedure. Or if the repair was symptom related, duplicate the condition under which the customer concern occurred to verify the repair. If the customer concerns re-occurs, return to Symptoms - Engine Controls and perform the appropriate symptom diagnostic.