LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2006 >> Uplander Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EBCM To BPMV Screws
    GM213438Courtesy of GENERAL MOTORS CORP.
  1. Connect the pump motor connector (3) to the bottom of the EBCM.
  2. Install the EBCM (1) to the BPMV (4).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 6 EBCM to BPMV retaining bolt/screws (2).

    Tighten:  Tighten the retaining bolt/screws to 2.9 N.m (26 lb in).

    4. Fig 2: Identifying EBCM Harness Connector
    GM230405Courtesy of GENERAL MOTORS CORP.
  4. Connect the EBCM harness connector.
  5. Reengage the locking tab (1) to the EBCM harness connector.
  6. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.8L or Air Cleaner Intake Duct Replacement in Engine Controls - 3.6L (LY7).
  7. Install the front fender upper diagonal brace. Refer to Brace Replacement - Front Fender Upper Diagonal in Body Front End.
  8. Install the fuel injector sight shield, 3.8L engine only. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.
  9. Turn the ignition switch to the RUN position, do not start engine.
  10. Perform the Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals