Engine Control Module: Service and Repair

Engine Control Module Replacement

Removal Procedure






Caution: Refer to Battery Disconnect Caution.

1. Disconnect the negative battery cable.
2. Disconnect the engine control module (ECM) connectors.
3. Remove the ECM retaining bolts.
4. Remove the ECM from the ECM mount.

Installation Procedure




1. Position the ECM in place.

Notice: Refer to Fastener Notice.

2. Install the ECM to the ECM mount and install the retaining bolts.

Tighten the ECM retaining bolts to 4 N.m (35 lb in).

3. Connect the negative battery cable.
4. Perform the following procedures:

* Program the ECM
* Crankshaft Position System Variation Learn
* Idle Learn

5. Refer to Control Module References for programming and setup information. Programming and Relearning