LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Corvette Base, 2D Convertible, Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of EBCM & BPMV
    GM772017Courtesy of GENERAL MOTORS CORP.
  1. Clean the sealing surface of the BPMV with denatured alcohol, or equivalent, and a clean shop cloth.
  2. Ensure the motor connector (3) is in place on the EBCM (1).
  3. Install the EBCM to the BPMV. Use care when aligning the EBCM (1) to the BPMV electrical terminals (2).
    4. NOTE: Refer to Fastener Notice .
  4. Install the 4 EBCM-to-BPMV retaining bolts. Tighten the bolts in a criss-cross pattern.

    Tighten: 

    • First pass: Tighten the bolts to 3 N.m (27 lb in).
    • Second pass: Tighten the bolts to 6 N.m (53 lb in).

    5. Fig 2: View Of EBCM And Electrical Connector
    GM899234Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector to the EBCM (3). Ensure the cam (2) is secured by the lock tab.
  6. Connect the electrical connector to the brake fluid pressure sensor.
    7. Fig 3: View Of EBCM Connector, Bracket & Bolts
    GM1274761Courtesy of GENERAL MOTORS CORP.
  7. Install the two BPMV bracket bolts.

    Tighten:  Tighten the bolts to 27 N.m (20 lb ft).

  8. Lower the vehicle.
  9. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (6.0L) or Battery Negative Cable Disconnection and Connection (7.0L) .
  10. If installing a replacement module, refer to Service Programming System (SPS) .
  11. If installing a replacement module, program the replacement module. Refer to Control Module References .
  12. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals