LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2007 >> Uplander Base, 3.9 W >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Digital Radio Antenna Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Monte Carlo and 2007 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Routing Antenna Cable
    GM859172Courtesy of GENERAL MOTORS CORP.
  1. Install the antenna cable retainers to the receiver bracket.
  2. Connect the antenna cable to the digital radio receiver.
  3. Attach the wire or string used in the removal procedure to the cable being installed.
  4. Carefully pull the antenna cable through the rear shelf into the passenger compartment.
  5. Install the right rear compartment trim panel.
  6. Remove the wire or string from the antenna cable.
  7. Route the antenna cable between the dome lamp harness and the upper quarter panel.
  8. Install the antenna cable to the dome lamp harness clips.
  9. Fig 2: Removing Antenna Cable
    GM859171Courtesy of GENERAL MOTORS CORP.
  10. Install the antenna cable retainer (3) to the rear header (2).
  11. Connect the antenna cable to the antenna base cable connector.
  12. Install the antenna cable mastic patch/tape at the roof.
  13. Install the rear of the headliner. Refer to Headlining Trim Panel Replacement (Impala) or Headlining Trim Panel Replacement (Monte Carlo) .
  14. Install the right rear upper quarter trim panel. Refer to Rear Quarter Upper Trim Panel Replacement (Impala) or Rear Quarter Upper Trim Panel Replacement (Monte Carlo) .