LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2008 >> Impala SS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls And Fuel - 3.5L - Introduction (2 Of 2)) >> Repair Instructions >> Mass Airflow Sensor/Intake Air Temperature Sensor Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor
    GM1556017Courtesy of GENERAL MOTORS CORP.
  1. Install the MAF/IAT sensor seal, if necessary.
  2. Install the MAF/IAT sensor to the air cleaner housing.
    3. NOTE: Refer to Fastener Notice .
  3. Install the MAF/IAT sensor bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

    4. Fig 2: Locating MAF/IAT Sensor Electrical Connector
    GM1608290Courtesy of GENERAL MOTORS CORP.
  4. Connect the MAF/IAT sensor electrical connector (3).
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About LEMON Manuals