Circuit/System Testing
WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connectors at the BCM.
- Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground circuit terminals listed below and ground.
- Terminal 1 X3
- Terminal 5 X3
- Terminal 9 X4
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the B+ circuit terminals listed below and ground.
- Terminal 3 X3
- Terminal 10 X4
- If the test lamp does not illuminate, test the appropriate B+ circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the BCM.