Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Clutch Control Module Screws

Courtesy of GENERAL MOTORS CORP.

Position the clutch control module on the torque tube.

CAUTION: Refer to Fastener Caution .

Install the mounting screws for the clutch control module.
Tighten: Tighten the screws to 8 N.m (71 lb in).

Fig 2: Identifying Clutch Control Module Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Reconnect the electrical connectors for the clutch control module.

Fig 3: View Of Torque Tube

Courtesy of GENERAL MOTORS CORP.

Lift the torque back into position.

Fig 4: Identifying Torque Tube Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

Install the torque tube mounting bolt.
Tighten: Tighten the bolt to 185 N.m (137 lb ft).
Install the propeller shaft. Refer to Propeller Shaft Replacement
Remove the support and lower the vehicle.
Reprogram the clutch control module. Refer to Control Module References .