Removal Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the propeller shaft assembly. Refer to Propeller Shaft Replacement .

Fig 1: Identifying Torque Tube Mounting Bolt

Courtesy of GENERAL MOTORS CORP.

Remove the torque tube mounting bolt.

Fig 2: View Of Torque Tube

Courtesy of GENERAL MOTORS CORP.

NOTE: DO NOT allow the torque tube to hang, support with a suit stand.

Lower the torque tube to gain access to the clutch control module.

Fig 3: Identifying Clutch Control Module Electrical Connectors

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connectors from the clutch control module.

Fig 4: View Of Clutch Control Module Screws

Courtesy of GENERAL MOTORS CORP.

Remove the screws for the clutch control module.
Remove the clutch control module from the torque tube.