LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Wiper System And Washer System) >> Diagnostic Information and Procedures >> Rear Wiper System Malfunction >> Component Testing >> I/P Switch Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

I/P Switch Assembly

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the multifunction switch - I/P.
  2. Rear wiper switch in the OFF position, test for infinite resistance between the ignition terminal 6 and the signal terminal 5.
    • If not the specified value, replace the I/P switch assembly.
  3. Rear wiper switch in the ON position, test for less than 5 Ω between the ignition terminal 6 and the signal terminal 5.
    • If not within the specified range, replace the I/P switch assembly.
scientia non olet · About LEMON Manuals