Removal Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Place the module in the closed/flush position.
Lower the headliner. Refer to Headlining Trim Panel Replacement .
Disconnect the electrical connector from the motor/actuator.
Remove the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .

Fig 1: Identifying Cam Assembly, Timing Hole & Lifter Arm

Courtesy of GENERAL MOTORS CORP.

Push the cam assembly (2) forward until the timing hole (3) in the cam is aligned with the timing hole (4) in the lifter arm (1).

Fig 2: View Of Pin & Drive Motor

Courtesy of GENERAL MOTORS CORP.

NOTE: Both mechanisms should now be in the closed position.

Insert a pin (1) in the holes on both sides of the module to hold the position while installing the drive motor.