Component Testing
WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
Liftgate Handle Switch
- Ignition OFF, disconnect the harness connector at the liftgate handle switch.
- Test for infinite resistance between the signal terminal 1 and the low reference terminal 2 with the switch in the open position.
- If not the specified value, replace the liftgate handle switch.
- Test for less than 2 Ω between the signal terminal 1 and the low reference terminal 2 with the switch in the closed position.
- If greater than the specified range, replace the liftgate handle switch.
Liftgate Close Switch
- Ignition OFF, disconnect the harness connector at the liftgate close switch.
- Test for infinite resistance between the signal terminal 1 and the low reference terminal 2 with the switch in the open position.
- If not the specified value, replace the liftgate close switch.
- Test for less than 2 Ω between the signal terminal 1 and the low reference terminal 2 with the switch in the closed position.
- If greater than the specified range, replace the liftgate close switch.