LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection >> Repair Instructions >> Object Alarm Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Electrical Connector & Rear Object Detection Module
    GM733623Courtesy of GENERAL MOTORS CORP.
  1. Align the rear object detection module to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the rear object detection module mounting bolts and tighten to 10 N.m (89 lb in)  .
  3. Install the electrical connector to the rear object detection module and press in the locking tab.
  4. Install the rear compartment side trim. Refer to Rear Quarter Trim Panel Replacement - Right Side .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals