LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Uplander Base, 3.9 1 >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of EBCM And BPMV
    GM255233Courtesy of GENERAL MOTORS CORP.
  1. Clean the BPMV surface with alcohol using a clean rag.
  2. Install the EBCM (1) to the BPMV.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the 6 screws that attaches the EBCM to BPMV and tighten.
    • the top 4 mounting screws to 5 N.m (44 lb in)  . Tighten screws in an X pattern.
    • the bottom 2 mounting screws to 5 N.m (44 lb in)  .
  4. Connect the pump motor connector to the bottom of the EBCM.
    5. Fig 2: Identifying Electronic Brake Control Module Connector
    GM1544732Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical harness connector (2) to the EBCM.
  6. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
  7. If a new EBCM was installed, the EBCM must be programmed. Refer to Control Module References .
  8. Turn the ignition switch to the RUN position, do not start engine.
  9. Perform the diagnostic system check. Refer to Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals