LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Malibu LS, 2.4 B >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.4L - Repair Instructions >> Repair Instructions >> Engine Control Module Replacement (LAT) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Engine Wiring Harness & Retainers
    GM1889667Courtesy of GENERAL MOTORS CORP.
  1. Set the ECM (2) into the bottom of the bracket and push the ECM towards the battery until the ECM snaps into place and is secured by the retainers (1).
    2. Fig 2: Locating Engine Wiring Harness Electrical Connectors & ECM
    GM1889666Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connectors (2) to the ECM.
  3. Install the engine wiring harness clips (3) to the ECM bracket (4).
    4. Fig 3: View Of Body Wiring Harness Electrical Connector & Engine Control Module (ECM)
    GM1889665Courtesy of GENERAL MOTORS CORP.
  4. Connect the body wiring harness electrical connector (1) to the ECM.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (LAT) .
  6. Program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals