Rear Object Alarm Module Scan Tool Information
Park Assist Module Scan Tool Data Parameters
| Parameter | System State | Expected Value | Definition |
|---|---|---|---|
| Operating Conditions: Ignition ON, Engine OFF, Park Assist System Enabled | |||
| Battery Voltage | - | Varies | The scan tool displays the current battery voltage. |
| Loudspeaker Feed Voltage Output | - | Varies | The scan tool displays the voltage output to the loud speaker. |
| Park Assist Disable 1-7 History | - | Varies | The scan tool displays Empty, Manual Disable, Park Brake, Hitch/Obj Attach, Reverse Ovrspeed, Inhibit, Sens Disturbance, or Sensor Ring Time. This parameter displays the last seven reasons why the park assist system was disabled in the history data. |
| Park Assist System Status | - | Enable | The scan tool displays Disable, Enable, Inhibit or Failed/Block. This parameter displays the current state of the park assist system. |
| Power Mode | - | Accessory | The scan tool displays Off, Accessory, Run or Crank Request. This parameter displays the current state of the ignition switch. |
| Rear Region 1 | - | No Detect | The scan tool displays No Detect or Zone 1-8. This parameter displays the distance an object is from the object alarm sensor in zones. |
| Rear Region 2 | - | No Detect | The scan tool displays No Detect or Zone 1-8. This parameter displays the distance an object is from the object alarm sensor in zones. |
| Rear Region 3 | - | No Detect | The scan tool displays No Detect or Zone 1-8. This parameter displays the distance an object is from the object alarm sensor in zones. |
| Sensor Feed Voltage Output | - | Varies | The scan tool displays the voltage supplied to the object alarm sensors. |
| Vehicle Speed | - | 0 | The scan tool displays the vehicle speed in km/h (mph). |
Park Assist Module Scan Tool Output Controls
| Scan Tool Output Control | Description |
|---|---|
| Clear History Data | The object alarm module clears the park assist disable history when commanded by the scan tool. |