Installation Procedure
- Install a stationary window into the opening. Refer to Adhesive Installation of Windshields .
- Install the windshield side reveal moldings screws.
Tighten: Tighten the windshield side reveal moldings screws to 2 N.m (18 lb in).
- Reposition the front door sealing weatherstrips to the pinch-weld flange.
- Install the push-pin retainers to the front door sealing weatherstrips located at the base of the windshield pillar.
- Install the cowl air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
- Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement (Traverse) or Windshield Wiper Arm Replacement (Acadia) or Windshield Wiper Arm Replacement (Enclave) or Windshield Wiper Arm Replacement (OUTLOOK) .
- Install the rearview mirror. Refer to Inside Rearview Mirror Replacement .
- Install the rain sensor, if equipped.
- Close the hood.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
CAUTION:
Refer to Fastener Caution
.