Circuit/System Testing
WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate headlamp assembly.
- Test for less than 5 Ω between the ground circuit terminal listed below and ground:
- Left headlamp - terminal 4
- Right headlamp - terminal 10
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Disconnect the harness connector at the headlamp right.
- Ignition ON, headlamps ON, connect a test lamp between the ignition circuit terminal 1 and ground. The test lamp should illuminate.
- If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
- If all circuits test normal, replace the appropriate headlamp assembly. Verify that the customer concern is not still present.
- If the customer concern is still present, replace the headlamp right.