LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Wiring Harness Electrical Connector
    GM1858010Courtesy of GENERAL MOTORS CORP.
  1. Drain the cooling system. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac N Fill) .
  2. Slide the electrical connector heat shield up the wiring harness.
  3. Disconnect the engine wiring harness electrical connector (8) from the engine coolant temperature (ECT) sensor (9).
    4. Fig 2: View Of ECT Sensor
    GM1836047Courtesy of GENERAL MOTORS CORP.
  4. Remove the ECT sensor.
scientia non olet · About LEMON Manuals