LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 266 (Sunroof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2011 GMC Acadia, 2011 Chevrolet Traverse, and 2011 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION:

    Refer to Fastener Caution .

  1. Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .

    Tighten 

    Tighten the screws to 3.5 N.m (31 lb in).

  2. Connect the electrical connector to the motor/actuator.
    3. Fig 1: Sunroof Track Dowel Pins & Holes
    GM2413522Courtesy of GENERAL MOTORS CORP.
  3. Remove the dowel pin (1) from the holes (2) on both sides of the sunroof frame that held the cams in position while installing the motor/actuator.
  4. Install the sunroof window. Refer to Sunroof Window Replacement .

    Tighten 

    Tighten the screws to 4 N.m (35 lb in).

  5. Verify the operation of the sunroof.
  6. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process (New Motor) , Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor) , Sunroof Motor/Actuator Initialization/Teach Process (New Roller Sunshade) , Sunroof Motor/Actuator Initialization/Teach Process (Existing Roller Sunshade) .
  7. Install the headliner. Refer to Headlining Trim Panel Replacement .
scientia non olet · About LEMON Manuals